8.Start an M5 x 16mm Screw (85) with an M5 Star Washer (7) into the Right Handrail (33), and then start two M4.2 x 19mm Screws (10) into the Right Handrail. Tighten the M5 x 16mm Screw and then tighten the two M4.2 x 19mm Screws; do not overtighten the Screws.
Attach the Left Handrail (not shown) to the Console Assembly (91) in the same way. Note: There are no wires on the left side.
9.Remove the ties from the Cage Nuts (103) in the Right Handrail (33) and the Left Handrail (not shown). If necessary, press the Cage Nuts back into place. With the help of a second person,hold the Console Assembly(91) near the Right Upright (54).
Connect the Wire Harness (39) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Insert the connectors and the ex- cess wire downward into the Right Upright (54). Remove the wire tie from the Wire Harness.
8 |
| 85 | 10 |
| 33 | 7 | |
|
|
| |
| 91 |
|
|
9 |
|
|
|
33 |
| 91 |
|
103 |
| Console | |
| Console Wire | ||
39 |
| Wire | |
54 |
| Wire | 39 |
| Tie |
10
