The lower left display can show the elapsed time and the distance that you have walked or run during your workout. Each time you
change the incline, the display will show the incline setting for a few seconds. Note: When a workout is selected, the display will show the time remaining in the workout instead of the elapsed time.
The lower right display can show the speed of the walking belt and the approximate number of calories that you have burned during your
workout. The display will also show your heart rate when you use the handgrip pulse sensor (see step 6).
The upper display can show the elapsed time, the distance that you have walked or run, the approximate number of calories you have
burned, or the speed of the walking belt. Press the Display button repeatedly until the upper display shows the information that you are most interested in viewing. Note: While information is shown in the upper display, the same information will not be shown in the lower left or lower right display.
To reset the displays, press the Stop button, re- move the key, and then reinsert the key.
6.Measure your heart rate if desired. Before using the
handgrip pulse sensor, remove the sheets of
clear plastic from 
the metal con-Metal Contacts tacts. In addition,
make sure that your hands are clean.
To measure your heart rate, stand on the foot rails and place your hands on the metal contacts— avoid moving your hands. When your pulse is detected, your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds.
7.When you are finished exercising, remove the key from the console.
Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest set- ting when you fold the treadmill to the storage position, or you may damage the treadmill. Next, remove the key from the console and put it in a secure place.
When you are finished using the treadmill, switch the reset/off circuit breaker to the “off” position and unplug the power cord. IMPORTANT: If you do not do this, the treadmillʼs electrical compo- nents may wear prematurely.
16
