Connections (Continued)
Basic TV Connections
Make one of the following connections, depending on the capabilities of your existing equipment.
RF coaxial connection
Connect the RF.OUT jack on the DVD+VCR to the antenna in jack on the TV using the supplied
ote
If you use this connection, tune the TV to the DVD+VCR’s RF output channel (CH 3 or 4).
How to set the DVD+VCR’s RF output channel
1.Set the TV to the VCR channel (3 or 4) depending upon the selected channel.
2.When the DVD+VCR is turned off, press and hold CH (V/v) on the front panel for about five seconds.
It will turn itself on and “RF03” or “RF04” appears in the dis- play window.
3.Press CH (V/v) on the front panel or CH (v/V) on the remote control to change the RF output channel (CH 03 or CH 04).
4.Turn off the DVD+VCR.
Audio/Video connection
1DVD+VCR to the video in jack on the TV using the supplied video cable (V).Connect the DVD/VCR VIDEO OUT jack on the
2 Connect the Left and Right DVD/VCR AUDIO OUT jacks on the DVD+VCR to the audio left/right in jacks on the TV (A1) using the supplied audio cables.
ote
If you use this connection, set the TV’s source selector to VIDEO.
Rear of TV
ANTENNA | AUDIO INPUT | VIDEO | ||
INPUT | INPUT | |||
|
| |||
| L | R |
| |
R A1 V
Rear of DVD+VCR
Optional, Preferred TV Connections
ote
You can ONLY watch and listen to DVD playback through the connections shown below.
S-Video connection
1to the
Connect the Left and Right AUDIO OUT jacks of
2 the DVD+VCR to the audio left/right in jacks on the TV using the supplied audio cables (A2).
Component Video / Progressive Scan connection
zIf your television is a
zIf your TV does not accept the Progressive Scan for- mat, the picture will appear scrambled if you try Progressive Scan on the DVD+VCR.
1SCAN VIDEO OUT jacks on the DVD+VCR to the
corresponding in jacks on the TV using an optional Y Pb Pr cable (C).Connect the COMPONENT / PROGRESSIVE
2the DVD+VCR to the audio left/right in jacks on the TV (A2) using the supplied audio cables.Connect the Left and Right AUDIO OUT jacks of
otes
zSet Progressive Scan to “On” in the setup menu for progressive scan signal, see page 18.
zWhen you use Component Video signal, set Progressive Scan to “Off” in the setup menu.
zProgressive scan does not work with the analog video connections (yellow VIDEO OUT jack).
Rear of TV
COMPONENT VIDEO INPUT | AUDIO INPUT | |||||
INPUT | ||||||
|
|
|
|
| ||
Pr | Pb | Y | R | L |
| |
C | A2 S |
Rear of DVD+VCR
12
