Attaching the Legs
Step 1.
The four legs have a double button at one end and a single button beneath it.
With the hub sides facing up, place the motor housing and pivot housing on the floor.
Position legs so their single buttons also face up.
Insert legs into the motor housing and pivot housing as shown. The double buttons must fit into the channels inside the housings.
Step 2.
Push each leg in until the double button snaps into the hole at the end of the channel. Then swing the legs outward until the single button snaps
Hub
Double
button
Single button
Channels PUSH
Button in hole
Notch
Step 2.
Begin by inserting a 11/8" screw all the way into the small hole on one foot. Position the foot as shown at right, so the text and viewing hole are not on the short side of tube near the wire end. Then use viewing hole to line up the end of the screw with the hole in the tube. Tighten the screw securely. Repeat above steps for the other feet.
CHECK that feet are secure by wiggling the feet.
Step 3.
Push a plastic tip onto all four of the feet. Tap leg tips on
the floor to be sure they are completely on.
The hole in the plastic tip permits future tightening of the screw if needed.
Wire end
Short side
of tube
Text and
viewing hole
into its notch, as shown.
Attaching the Base Tubes |
Step 1. |
CHECK that the legs are properly attached by twist- ing them in the housings. They should resist twist- ing. If a leg twists and buttons come out of their holes, insert leg into the housing again. Be sure to align BOTH double buttons with BOTH sets of channels inside the housings.
| Bracket hole | |
Push the legs firmly onto | points toward | |
rear of swing | ||
the rear base tube | ||
| ||
exactly as shown. |
|
Attaching the Feet
Step 1.
Identify the front and rear base tubes from pictures at right. The feet to use with each tube can be identified by the text “FRONT BOTTOM” or “REAR BOTTOM” printed on them.
Front base
tube
Front
foot
Rear base
tube
Rear
foot
Step 2.
Push the other two legs onto the front base tube.
CHECK that all tubes are securely attached.
CHECK that the parts of the frame are assembled in the positions shown.
Switch side of
motor PUSH housing
Motor
housing 
(switch side)
Straight rear
base tube
PUSH
Bent front base tube
5 |
6
