Installing the Batteries
Starting the Swing
Step 1.
With baby out of swing, open the battery compartment lid by inserting a coin (penny, nickel or dime) into the coin slot. After the lid pops open, swing it down and remove it.
Coin slot
CHECK that all parts are securely fastened together before using the swing.
Step 1.
Open the waist belt. Place baby in the seat. (If your child is very small, you may want to use
Step 2.
Insert four “D” cells. Alkaline or
Step 3.
To replace lid, put the two tabs of the lid into the two slots in the bottom of the motor housing. Swing lid up, and press it into place until you hear the latch click.
Step 2.
Fasten the waist belt. Adjust belt as needed to get a snug fit around your child.
Do not depend on the tray alone to hold your baby. Always secure your baby with the waist belt when your child is in the swing.
Step 3.
To start swing, slide the speed button to the desired speed and give the swing a gentle push.
Observe the swinging motion for a minute. It takes time for the swing to adjust to a set- ting. Change setting if needed.
Step 4.
To turn swing off, slide switch to the center OFF position.
Indicator Light- Red light comes on when swing is turned on.
Your seat may be stopped at any time the motor is running without damaging the motor. Push swing to restart.
If your swing motor stops operating by itself, a protective device may have been activated. Turn off motor, wait three minutes, then restart swing.
11 |
|
12 | |
|
|