Using the Swing
CHECK that all parts are
securely fastened together Hanger before using the swing.
Step 1.
Place carrier in hanger.
Be sure handle notches are seated in the hanger.
Step 2.
Thread both sides of seat belt through the buckles as shown.
CHECK that the belt is thread- ed correctly by pulling on the seat belt. The belt should not slip through the buckle.
Step 3.
Open tray and place baby in the seat. (If your child is very small, you may want to use
Step 4.
Place crotch strap between child’s legs and snap both side buckles to the center buckle. Adjust belt as needed to get a snug fit around your child.
To release, push in on front of buckle.
Step 6.
Adjust the control switch to medium setting.
• For a lower speed, push the
•control switch toward “low.”
•For a higher speed, push the
•control switch toward “high.”
Notch | Step 7. |
|
Give seat a push to start the swing.
Observe the swinging motion for a minute. It takes time for your swing to adjust to a new setting.
NOTE: A small, quiet baby will swing higher on each setting than a larger, more active baby.
Indicator Light- ON/OFF light comes on when swing is turned on.
NOTE: SEAT MAY BE STOPPED ANY TIME MOTOR IS RUNNING WITHOUT DAMAGING MOTOR.
PUSH SWING TO RESTART.
IF YOUR SWING MOTOR STOPS OPERATING
BY ITSELF, PROTECTIVE DEVICE MAY HAVE BEEN
ACTIVATED. TURN OFF MOTOR,WAIT 3 MINUTES,
THEN RESTART SWING.
D b b
K
A a
(
r
A d c
N r
D b s s a
A fo c
C
C
Pr
Sw wo op
Step 5.
Close the tray. CHECK that tray is latched by pulling up on the tray.
|
|
| Se | |
|
|
| do | |
|
|
| sw | |
|
| Do not depend on the tray or seat | ve | |
|
| |||
|
|
| hi | |
belt alone to hold your baby. Always secure your | ||||
| ||||
baby with both the seat belt and tray when your |
| |||
child is in the swing. |
| |||
9 | 10 |
