Attaching the Seat Cover
Using the Swing
Step 1.
Slide the pocket of the cloth seat cover over the top of the seat as shown.
Step 2.
Pull both ends of seat belt through the slots in the seat
CHECK that all parts are securely fastened together before using the swing.
Step 1.
Place carrier in hanger.
Be sure handle notches are seated in the hanger.
Hanger
Notch
cover.
Step 3.
Fold cover around bottom of seat.
Be sure the seat cover at armrest does not interfere with tray latching.
Using the Tray
Unlatch the tray by squeezing the two latches under the tray at the same time, and lift up tray. Be careful not to let tray hit your baby when lifting or closing tray.
To latch tray, push down firmly.
Tray must be latched at all times when baby is in the swing.
Adjusting the Stand
To change recline of the carrier, squeeze the adjustment wire and move to desired position.
To adjust for rocking, move the adjustment wire to the highest position.
Do not change seat recline with baby in infant carrier.
Be aware that infant move- ment or rocking may cause the infant carrier to move on a table.
9 |
Step 2.
Thread both sides of seat belt through the buckles as shown.
CHECK that the belt is threaded correctly by pulling on the seat belt. The belt should not slip through the buckle.
Step 3.
Open tray and place baby in the seat. (If your child is very small, you may want to use
Step 4.
Place crotch strap between child’s legs and snap both side buckles to the center buckle. Adjust belt as needed to get a snug fit around your child.
To release, push in on front of buckle.
Step 5.
Close the tray. CHECK that tray is latched by pulling up on the tray.
Do not depend on the tray or seat belt alone to hold your baby. Always secure your baby with both the seat belt and tray when your child is in the swing.
10
