6.4 Using LATCHto install Base | Tongue | ➌ | |
1. | For ease of installation, extend LATCH | ||
2. | to its maximum length. |
|
|
Position base in vehicle seat as |
|
| |
3. | shown. |
|
|
Thread LATCH through base belt |
|
| |
| path normally used for vehicle seat |
|
|
| belt. Make sure that LATCH is UNDER |
| ➍ |
| tongue on base ➌. |
| |
4. | Belt must lay flat and not be twisted. |
|
|
Hook Connectors to vehicle lower |
|
| |
| anchors. Pull firmly on Connectors to |
|
|
5. | be sure they are attached ➍. |
| ➎ |
Tighten LATCH by pushing down |
| ||
| hard on base and pulling the |
|
|
6. | adjustment belt ➎. |
|
|
NEVER put two LATCH connectors on |
|
| |
| one vehicle LATCH anchor unless |
|
|
| specifically allowed by the vehicle |
| ➏ |
7. | manufacturer ➏. |
| |
Test infant restraint for secure |
|
| |
| installation as described in infant |
|
|
8. | restraint “Final Safety Check” p.36. |
|
|
Check that the LATCH stays tight and does not slip from the | |||
| tightened position. If it does not stay tight, try another |
| |
| seating position or contact Customer Service. |
|
|
| 33 |
|
|
