308371 7
Installation
12. Align the agitator paddle (12) on the agitator shaft
(14) as instructed for your model, as follows:
Models 236662 and 236663 (10 & 15 Gallon)
Align the top of the paddle hub (G) with the mark
(H) on the agitator shaft (14).
Model 236661 (5 Gallon)
If a 5 gallon pail is to be placed inside the pressure
tank (5 gallon tank only), align the top of the
paddle hub (G) with the upper mark (J) on the
agitator shaft (14). If a pail will not be placed inside
the tank, align top of hub (G) with the lower mark
(H) on the agitator shaft (14).
After the paddle (12) is properly aligned, apply low
strength sealant to the two setscrews (13) and
firmly secure the paddle with the setscrews.
13. See Fig. 5. Remove plug from air inlet manifold
(N). Remove the elbow (37) from the end of the air
hose (21) and attach to the pressure tank’s air inlet
manifold (N).
14. Connect the swivel end of the air hose (21) to the
elbow (37).
15. See Fig. 5. Remove the gear reducer’s oil level
plug (L) from the street elbow and check the oil
level in the reducer housing. The oil should never
be higher than the oil level plug. If necessary, drain
or add oil until the proper oil level is attained.
Screw the oil level plug back onto the street elbow.
NOTE: Special high temperature synthetic gear oil is
required for the gear reducer. Use only Graco oil,
part number 204559.
Apply low strength (cyanoacrylate) thread sealant.
1
Fig. 4
13
24
25
J
H
14
G
12 K
23
02264
1
1/2”
(13 mm)
11
25
36
2 & 3
11
26