![](/images/new-backgrounds/1042285/4228533x1.webp)
Service
Diaphragm Repair
Tools Required
DTorque wrench
D13 mm socket wrench
D15 mm socket wrench (aluminum models) or
1 in. socket wrench (stainless steel models)
D19 mm
D
D
Disassembly
NOTE: A Fluid Section Repair Kit is available. Refer to page 23 to order the correct kit for your pump. Parts included in the kit are marked with an asterisk, for example (401*). Use all the parts in the kit for the best results.
WARNING
To reduce the risk of serious injury whenever you are instructed to relieve pressure, always follow the Pressure Relief Procedure on page 10.
1.Relieve the pressure.
2.Remove the manifolds and disassemble the ball check valves as explained on page 16.
3.Using a 13 mm socket wrench, remove the screws (106 and 112) holding the fluid covers (101) to the air covers (23). Pull the fluid covers (101) off the pump. See Fig. 11.
1
Apply
2Arrow (A) must point toward air valve (B).
3Muffler not included on Model No. 253485.
B
23
101
A 2
106 1
3
112 1
| 03273C | |
Fig. 11 | ||
|
308441 17