
10.Place assembly on a spacer, such as a two inch wide roll of tape, and tap piston rod through throat seal and bearing.
CAUTION
Keep rod straight to prevent damage to throat seal.
TI9106a
FIG. 14: Tap Piston Rod
11.Tap cylinder onto piston rod as shown in FIG. 15. Be careful to not score piston seal. Continue tapping cylinder until it seats in bore of block.
Use grease to aid in insertion of piston rod into cyl- inder.
Cylinder Assembly
TI9107a
Seat Cylinder in Bore TI9108a
FIG. 15: Tap Cylinder onto Piston Rod
12.Once cylinder is seated in bore, remove two socket head set screws from block and plate assembly.
13.Assemble cylinder and block assembly to remaining pump components. See Proportioning Pumps man- ual 311391 for instructions.
312348B | 7 |