PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your stroller.
If any parts are missing, call Customer Service
at
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
No tools required for assembly.
Step 2.
Be sure frame is latched as shown before continuing assembly.
Latch
To Assemble Front Wheels
Step 4.
Place one rear wheel, red retainer, cap, and hubcap (only on certain models) on one end of rear axle in order as shown below. Push red retainer onto axle BEFORE attaching white cap. Repeat on other side.
| Wheel | Hubcap (only on |
|
| |
Spokes |
| certain models) |
|
| |
toward |
| Cap (white) |
inside |
| |
| Attach AFTER | |
|
|
To Assemble Arm Bar
Step 1.
Push ends of bar into open- ings at front of stroller, until the bar locks in place.
Pull on bar to be sure both sides are attached.
Frame | Arm bar |
Step 1.
Snap swivel lock button onto wheel mount as shown. This must be done BEFORE pin is inserted (next step).
retainer is on axle |
NOTE: It is normal to be able to wiggle bar slightly.
Step 2.
Snap fabric flap onto the bar. 
Rear | Front canopy |
canopy | (only on |
| some models) |
| Rear axle |
| Pin (2) |
Step 2.
Insert pin through hole in wheel mount. Then push round end of a front wheel assembly up onto pin as shown until it snaps into place.
NOTE: Check wheel attachment by pulling down on the front wheel assembly.
Step 3.
Insert pin
Round end 
Rear axle
Snap red retainer into axle groove. Then snap cap over red retainer as shown. Be sure cap is snapped securely over red retainer. Snap the hubcap (only on some models) on last.
Retainer (red)
Wide end toward wheel
To Use Brakes
Always apply both brakes to park stroller.
Push DOWN to park.
Rear hubcap (2, |
| |
only on some models) |
| |
Cap | Retainer | Swivel lock |
(2, 1 extra) | (2, 1 extra) | button (2) |
Front wheel | Rear wheel (2) |
assembly (2) |
|
|
|
To Unpack Stroller
Step 1.
Flatten stroller carton to protect floor.
Open stroller on carton as shown until latched.
Flattened
carton
Repeat above steps for the | Push |
other side. | wheels up |
To Assemble Rear Wheels
Step 1.
Turn stroller over as shown.
Step 2.
Unsnap the basket flap from the rear brace, and slide rear axle through the hole in one axle bracket.
Continue to push the rear axle into the hole of the other axle bracket.
Step 3.
Snap the basket flap around both the rear axle and the rear brace.
HINT: This may be easier if stroller is partially folded. See “To Fold Stroller” instructions.
6
To Unfold Stroller
Step 1.
Release storage latch (on inside of handle on right side of stroller).
Step 2.
Unfold stroller as shown.
Be certain the stroller is fully erected and latched before allowing your child near the stroller.
To Raise Footrests
Lift footrest and hook wire into footrest bracket.
7
Lift UP to stroll.
To Change to Swivel or Non-swivel Wheels
Front swivel wheels lock for use on uneven surfaces such as grass, stones or gravel.
NOTE: Before locking swivels, first push stroller forward a few feet to ensure that the wheels are correctly positioned.
Push buttons up or down, depending on model, to lock or release swivels. Turn swivel to check that it is locked or released.
8
