To Secure Your Child
To Install Rear Canopy
To Install Front Canopy (found only on some models)
Step 2.
Turn down fabric flaps to cover openings.
Avoid serious injury from falling or sliding out. Always use seat belt.
Step 1.
Place crotch strap between child’s legs and snap both side buckles to the center buckle. Adjust belt as needed to get a snug fit around your child.
Step 2.
Push in on front of buckle to release.
To Adjust Backs
Step 1.
Push back of seat slightly forward while squeezing lever as shown to unlock.
Step 2.
Adjust to desired position. Rear seat has four positions, front seat has three. You may use any combination of seat positions.
Step 3.
Step 1.
Fully recline the rear seat. Locate small knobs on the inside of the handle.
Step 2.
Hold canopy by mounting brackets as shown. Push brackets in slightly and align holes in brackets with knobs on handle. Mount brackets onto knobs.
Knob
Step 3.
Slide brackets down to latch.
Be sure fabric is not caught under brackets.
Step 4.
Snap canopy fabric to seat back.
Bracket
hole 
Knob
Step 1.
Fully recline the front seat.
Step 2.
Unsnap small flaps on top of
armrests.Push
Step 3.
Check that arrows on inside of canopy brackets face the front
of the stroller.
Push
Step 4.
Insert brackets through elastic, then through holes on armrests as shown.
Step 5.
Metal bar
Push both brackets down at the same time onto stroller frame until they snap into place. Brackets must fit over metal bars on inside of frame. Be sure fabric is not caught under brackets.
Step 6.
Resnap small flaps on armrests when front canopy is not in use.
Step 3.
When replacing the bar, turn back fabric flaps to expose openings, then push arm bar in until it locks in place.
Pull on bar to be sure both sides are attached.
To Fold Stroller
NOTE: Before folding, (1) adjust backs to upright posi- tion; (2) fold canopy; (3) lock rear brakes; (4) align front wheels with frame by pulling stroller slightly backward.
Step 1.
Pull up on latches on sides of handle to fold as shown and push handle forward slightly.
Step 2.
To return seat back to a more upright position, push forward on back until it snaps into desired position. (Front seat middle position locks for
To Remove Rear Canopy
Step 1.
To Adjust Canopies
Push or pull canopy to desired position.
Push down on secondary lock on right side of stroller as shown.
Continue pushing handle forward. Front wheels must align so they do not interfere with folding.
Child may slip into leg openings and strangle.
NEVER use front seat in a reclined carriage position unless footrest is raised to cover the front opening and wire is snapped into lower notch.
NEVER use rear seat in a reclined carriage position unless footrest opening 
behind front seat has first 
been closed by snapping the flap in six places to the back of the front seat.
Back of front seat
Rear seat
Fully recline the rear seat.
Step 2.
Unsnap canopy fabric from stroller.
Step 3.
Slide both brackets up, then push brackets in slightly to remove canopy.
Slide up and
push in
Canopy bag (on certain models) carries a maximum of 2 pounds (0.9 kg).
To Remove Arm Bar
Step 1.
Push in the tabs on both sides of the bar as shown. Pull the bar straight out.
Align front wheels
Step 3.
Lock storage latch (on inside
of handle on right side of stroller).
10
11
12
