Graco 8A12BKR owner manual Installing the Infant Restraint and Base Using Vehicle Belt

3. Buckle the vehicle belt. Make sure the buckle tongue goes into the correct buckle ➊. The seat

belt should not be twisted or turned.

➊

4. Tighten the vehicle seat belt. Refer to your vehicle ownerÊs manual and the instructions in „6.2.2 SAFE Vehicle Belt Systems‰, page.29-31, on tightening your vehicle belt when using the infant restraint without base.

To create a secure installation, push down	➋
hard with your free hand on the infant
restraint ➋ and pull and tighten the
vehicle belt.
5. Test infant restraint for secure installation
as described in infant restraint „Final Safety
Check‰ page.40.

7.2Installing the Infant Restraint and Base Using Vehicle Belt

When using the base to install the infant
restraint, the lock-off is ALWAYSused to
secure both belts of the lap or lap/shoulder
belt.	Lock-off	➌
1. Place the base in a rear-facing position
on a vehicle seat.

2. Open the lock-off and route the vehicle belt through the belt path and over the lock-off. ➌

34