Step 5. |
| To Use Accessory Bag |
Repeat steps 2 |
| If your bassinet is already installed, unsnap the four |
and 3 on other end |
| |
| snaps on the bassinet end flap from either end of | |
of changing table. |
| |
| Pack ’N Play. | |
If the short tubes |
| |
|
| |
have been inserted |
| Step 1. |
correctly, the changing |
| Snap accessory bag |
table should be able |
| |
to FOLD UP in the |
| onto end of Pack ’N |
center as shown. | Fold up | Play with four snaps |
| as shown. | |
|
|
Step 6.
Place pad in changing table with vinyl side up. Pull belt straps through holes in center of pad.
Step 7.
Insert VELCRO® straps into the four slots at the corners of changing table and attach to VELCRO® on underside of changing table. This will prevent pad from moving.
Step 2.
Snap bassinet end flap over the accessory bag with the four snaps.
To Fold Changing Table
Step 1.
Pull up on waist belt straps to fold.
Step 8.
Place changing table on Pack ’N Play as shown. You may use your changing table with or without your bassinet installed. Make sure tubes are securely over the sides of the Pack ’N Play.
Check that the changing table is supported
by the Pack ’N Play by pushing firmly down into center of changing table.
Step 2.
Ends of long tubes must point up when folded as shown.
Ends of tubes
point up
Step 3.
To carry or store your changing table with your folded Pack ’N Play, see “To Cover Your Pack ’N Play” section in these instructions.
15 |
|
16 | |
|
|
