Your new Graco® product has a toy mounting system in the tray.
If your model includes Mix ’N Move® toys and you want to use them right away, follow the instructions at right to install the toys.
If your model does not include the toys or if you do not wish to use toys right away, please follow the instructions below to install the covers.
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
Our goal is to make every product the best it can be! We are also committed to supporting our products after purchase. If you need replacement parts or would like to speak to Graco about your product, please contact our Customer Service Department at
or visit our Internet website, www.gracobaby.com.
To Install Covers
If you are not installing Mix ’N Move® toys, you will need to use the small covers found in your hardware bag. To insert a cover into the tray of your product, first push one side into a notch, then push in the other side.
© 2000 Graco
To Install Toys
(toy styles may vary)
Step 1.
If you have used a cover previously, you will need to remove it.
Remove child from product before removing covers.
With the aid of a flat head screwdriver, carefully pry up one edge of a cover until it comes off.
Throw the cover away immediately; it is not reusable.
Step 2.
Insert the two prongs on the toy base into a toy mount at the notches.
Step 3.
Turn toy base 1/4 turn until you feel the toy snap into place. Check that toy is firmly inserted by pulling on the toy.
Toy is removable (turn it the other way with a little pressure) so that you can replace it with other toys when desired.
