7.2 Installing the Infant Restraint Without Base Using Vehicle Belt (Alternate Method)
You must carefully follow the instructions provided by your vehicle manufacturer, in addition to the information in this manual. Before proceeding be sure you have read and understood section 6, “Choosing an Appropriate Vehicle Seat Location” on pages
Make sure vehicle is on level ground |
| |
so that the level indicator, which is attached |
|
|
to the infant restraint, can be used to properly |
|
|
recline the infant restraint. |
|
|
If a front passenger seat is used (see air bag |
|
|
warning, page 4), slide the vehicle seat |
|
|
rearward as far as possible from the |
|
|
dashboard. If a rear seat is used, make sure |
|
|
the seat in front of it is moved forward enough |
|
|
and is upright enough to allow room for the |
|
|
infant restraint. | Lap/Shoulder | |
1. Place the infant restraint without base in a | ||
Belt |
| |
|
|
2. Thread only the vehicle lap belt under both vehicle belt hooks . Fasten the vehicle belt.
3. Lift shoulder belt over handle and | |
around the back of carseat as |
|
shown. Slide shoulder belt into the |
|
shoulder belt guide as shown . |
|
35
