6.4Using LATCH to install Base
1. | For ease of installation, extend LATCH | Tongue |
| to its maximum length. |
|
2. | Position base in vehicle seat as |
|
| shown. |
|
3. | Thread LATCH through base belt |
|
| path normally used for vehicle |
|
| seat belt. Make sure that LATCH is |
|
| UNDER tongue on base . |
|
| Belt must lay flat and not be twisted. |
|
4. | Hook Connectors to vehicle lower |
|
| anchors. Pull firmly on Connectors to |
|
| be sure they are attached . |
|
5. | Tighten LATCH by pushing down |
|
| hard on base and pulling the |
|
| adjustment belt . |
|
6. | NEVER put two LATCH connectors on |
|
| one vehicle LATCH anchor unless |
|
| specifically allowed by the vehicle |
|
| manufacturer . |
|
7. | Test infant restraint for secure |
|
| installation as described in infant |
|
| restraint “Final Safety Check” p.40. |
|
8.Check that the LATCH stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service.
37
