FORWARD-FACING INSTALLATION WITH LATCH

1LATCH belt must be routed through opening in car seat for forward-facing(see page 23, fig. k).

Belt must lay flat and not be twisted.

2Adjust car seat to upright position (see pages 18 and 19, fig. b) and place forward-facingon vehicle seat equipped with LATCH anchors.

3For ease of installation, extend LATCH belt to its maximum length.

4Hook connectors to vehicle lower anchors (fig. a). Pull connectors to be sure they are securely attached (fig. b).

5Press down firmly in center of car seat to compress vehicle seat cushion while tightening LATCH belt by pulling adjustment belt (fig. c). Use your knee to press down in center of

car seat (fig. c).

6Pull front to back and left to right to check for secure installation (fig. d).

Check that the lower anchorage belt stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service (see back cover).

7Attach tether strap hook (A) to anchor hardware (B) and tighten adjustment belt to remove any slack (fig. e).

Periodically check that car seat is securely installed; adjust if necessary.

10

Page 12
Image 12
Graco ISPC008BA 08/02 manual FORWARD-FACING Installation with Latch