VEHICLE SEAT BELTS (continued)

Combination Lap/Shoulder Belt with Sliding Latch Plate

Pull on latch plate (fig. a). If belt slides freely through latch plate, a locking clip MUST

be used (see Pg. 31 “Locking Clip” section).

Some combination lap/shoulder belts with sliding latch plates may be converted into an “automatic locking mode” that will allow use without a locking clip. See vehicle owner’s manual and label on vehicle belts for instructions.

Combination Lap/Shoulder Belt with Locking Latch Plate

The locking latch plate on some seat belts may slip and loosen after being buckled on car seat if positioned at a certain angle. If this happens, flip the latch plate over (fig. b) and re-buckle. Test installation again to see if this works. If not, move car seat to another seating position.

Pull

(fig. a)

Flip

(fig. b)

30

Page 32
Image 32
Graco ISPC008BA 08/02 manual Combination Lap/Shoulder Belt with Sliding Latch Plate, Pull