Graco ISPC014BB manual Installation with Latch

INSTALLATION WITH LATCH

1Place car seat rear-facingon vehicle seat equipped with LATCH anchors (fig. a).

2Thread LATCH belt through car seat Slots. Belt must lay flat and not be twisted.

3For ease of installation, extend LATCH belt to its maximum length.

4Hook connectors to vehicle lower anchors (fig. b). Pull connectors to be sure they are securely attached to the anchor points. (fig. b).

5Press down firmly on car seat to compress vehicle seat cushion while tightening LATCH belt.

6

7

8

Pull front to back and left to right to check for secure installation (fig. c).

Check that the lower anchorage belt stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service (see back cover).

Check level indicator on car seat.

Vehicle must be on level ground

and child in car seat when checking level indicator.

Ball MUST be entirely in green zone (fig. d). If necessary, place rolled towels under car seat, at vehicle seat crease, until entire ball is in green zone. Then re-check level indicator.

Adjust handle (on certain models) to a position behind car seat.

Periodically check that car seat is securely installed and properly leveled; adjust if necessary.

14