Graco ISPC014BB manual Harness Assembly, Seat fig. o

SEAT PAD ASSEMBLY (continued)

❃Harness Assembly

15-Point Models :

Thread each end of harness strap from back to front through slot in tongues (fig. l).

DO NOT twist harness strap.

23-Point Models :

Make sure tongue and chest clip are on harness strap as shown (fig. m).

5-Point Models :

Thread each end of harness strap through chest clip.

Chest clip MUST be re-threaded exactly as shown. (fig. n)

3Thread each end of harness strap through matching slots of seat pad and car

seat (fig. o).

Read instruction manual for proper harness strap adjustments.

4Adjust harness strap length by inserting metal rod into loops that will position harness strap for proper snugness (fig. p).

Make sure the ROD is threaded through the same loop position on both sides.

5Replace metal rod into side slots and slide metal rod down below tab (fig. q).

Make sure tab holds metal rod securely.

WARNING

Only use metal rod supplied by Graco or child will not be restrained.

10