Graco LiteRiders Tongue , to its maximum length, 6.4Using LATCH to install Base, Belt must lay flat and not be twisted, 1.For ease of installation, extend LATCH

6.4Using LATCH to install Base1.For ease of installation, extend LATCHto its maximum length.2. Position base in vehicle seat as shown.

3.Thread LATCH through base belt path normally used for vehicle seat belt. Make sure that LATCH is UNDER tongue on base .

Belt must lay flat and not be twisted.

4. Hook Connectors to vehicle lower anchors. Pull firmly on Connectors to be sure they are attached .

Tongue 



5.Tighten LATCH by pushing down hard on base and pulling the adjustment belt .

6.NEVER put two LATCH connectors on one vehicle LATCH anchor unless

specifically allowed by the vehicle manufacturer .

7.Test infant restraint for secure installation as described in infant restraint “Final Safety Check” p.40.





8.Check that the LATCH stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service.

37