6.4 Using LATCH to install Base
1. | For ease of installation, extend LATCH | Tongue |
| to its maximum length. |
|
2. | Position base in vehicle seat as |
|
| shown. |
|
3. | Thread LATCH through base belt |
|
| path normally used for vehicle seat |
|
| belt. Make sure that LATCH belt is | |
| UNDER tongue on base . | |
|
| |
| Belt must lay flat and not be twisted. |
|
4. | Hook Connectors to vehicle lower |
|
| anchors. Pull firmly on Connectors to |
|
| be sure they are attached . |
|
5. | Tighten LATCH by pushing down | |
| hard on base and pulling the |
|
| adjustment belt . |
|
6. | NEVER put two LATCH connectors on |
|
| one vehicle LATCH anchor unless |
|
specifically allowed by the vehicle | | |
manufacturer . | ||
|
7. Test infant restraint for secure installation as described in infant restraint “Final Safety Check” p.38.
8.Check that the LATCH stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service.
34
