Turbine Kit Installation
One- and
106 (19)
(1)
104(25)
108 (82)
102 (24)
(6)
109 (83)
(18)
(5)
103 (42)
(48)
107 (31)
(34)
(33)
Fig. 3
(23)
105 (41)
(2)
(7)
(27)
7943B
4.Remove turbine gasket (25), three screws (6), turbine plate (82), and three turbine spacers (83).
NOTE: Steps 5 and 8 apply only if your
5.Remove turbine motor wires from spade terminals on speed controller (48).
6.Rotate turbine (24) from outlet fitting (18) and lift up from turbine spacers (23) and turbine duct (5) to remove.
7.Remove rocker switch (31) and wires connected to it (Fig. 4 wiring diagram).
8.Remove two remaining wires connecting speed controller (48) to red rocker switch (34) and filter indicator light (33).
Rocker Switch Installation and Wiring
See Wiring Diagram in Fig. 4.
1.In orientation shown in Fig. 3, install rocker switch (107) in hole left by removed switch (31).
2.Connect male tab end of one white wire (110) to spade terminal 2 of switch (107). Position spade to outside of switch to ease connection of second wire. Connect other end of white wire to spade terminal 5 of red rocker switch (34).
308924 3