Graco TI15605a Reassemble the Coupling, Adapter and Tie Rods to, Motor, Coupler Torque Values

Repair

			Table 1: Coupler Torque Values
			Pump Part No.	Coupler Torque Value
			(see page 3)	(items 103 and 105)
		101	J_17__	145-155 ft-lb (196-210 N•m)
			J_20__	90-100 ft-lb (122-135 N•m)
			J_23__	145-155 ft-lb (196-210 N•m)
			J_30__	90-100 ft-lb (122-135 N•m)
			J_33__	145-155 ft-lb (196-210 N•m)
			J_35__	90-100 ft-lb (122-135 N•m)
		108	J_40__	90-100 ft-lb (122-135 N•m)
		105 1	J_44__	145-155 ft-lb (196-210 N•m)
		104	J_45__	90-100 ft-lb (122-135 N•m)
			Reassemble the Coupling
		103 1
	106		Adapter and Tie Rods to the
			Motor
		122
			NOTE: Use this procedure only if the coupling adapter
			(105) and tie rods (106) have been disassembled from
		R	the motor, to ensure proper alignment of the motor shaft
			to the piston rod (R).
			1. See FIG. 6. Screw the tie rods (106) into the motor
			(101) and torque to 50-60 ft-lb (68-81 N•m).
			2. Fill the cavity in the bottom of the motor shaft with
	107		grease. Install the moisture cover (108) on the
		102	motor shaft. Screw the coupling adapter (105) into
	3 2		the motor shaft and torque as specified in Table 1.
			3. Assemble the coupling nut (103) to the piston rod
			(R).
		TI15606a	4. Orient the lower (102) to the motor (101). Position
			the lower on the tie rods (106). Lubricate the
1			threads of the tie rods. Screw the tie rod locknuts
	Torque as specified in Table 1.		(107) onto the tie rods. Tighten the locknuts and
2 Torque to 50-60 ft-lb (68-81 N•m).			torque to 50-60 ft-lb (68-81 N•m).
3	Apply lubricant.		5. Insert the collars (104) into the coupling nut (103).

FIG. 6. Reassembly (3000 and 4000cc Pump Shown)

Tighten the coupling nut onto the coupling adapter (105) and torque as specified in Table 1.

3A0538F 17