17
15
4
TORQUE
T
O
125 in–lb
(14 N.m)
B

C

A

0155
Fig.
27
14
0156
11 12
17
45
Fig. 28
 
Clamp
NOTE: A
standard steering wheel puller and two1/4–28
x 3 or 4 in. long screws are required to remove
the
clamp.
NOTE:
Refer to Fig. 27.
1 Loosen
the two screws (4) on the clamp (15), work
-
ing
through the slot at the bottom of the clutch hous
-
ing (17).
2 Install two screws (B) of the tool (A) in two of the
threaded holes in the clamp. Tighten the screw (C)
until
the clamp comes of
f.
3 Go to Reassembly, page 30, Step 3, or continue
below.
Clutch Housing
NOTE: Refer
to Fig 29–2.
1
Remove the capscrews (1
1) and
lockwashers (12) which hold the
clutch housing (17) to the engine (45).
2
Remove the engine key (14).
3
Pull of
f the clutch housing (17).
4
Go to
Reassembly
,
page 30, Step 1.