Flushina+a
14.
15.
KEY
A
Bleed-type master air valve
CAir line
3Fluid heater
6a Pump air regulator
6b Gun air regulator
9
3-way valve
13
Drain hose
44 Fluid regulator
45 Fluid filter
48 Filter drain valve
For a first-time flush, trigger the gun, and circulate
the solvent for 20 seconds.
16.
For flushina after soravina fluid, turn the 3-way
valve to Circulate. Trigger the gun periodically
whiie circulating the solvent. Periodically turn the
3-way valve to Drain to flush out some dirty
sol-
vent. Flush until the system is clean. Repeat with
clean solvent, if necessary.
17.
18.
19.
Raise the suction tube out of the solvent, trigger
the gun, and run the pump until air comes from the
gun. Turn the 3-way valve to Drain, and run the
pump until all air is expelled.
20.
Release the trigger, and close the fluid regulator
(44) and the air regulators (6a,6b).
Clean the filter screen, air cap, and fluid nozzle
separately.
Open the filter drain valve (48). Remove the filter
bowl, and reinstall the filter screen.
Thoroughly clean the inside and outside of the
suction tube.
You are now ready to prime the system with
another fluid or to store the system.
Fig. 10
c --