Troubleshooting
NOTE: Check all possible solutions before disassembling the pump.
Problem | Cause | Solution |
|
|
|
Uneven spray pattern | Bead pressure too low | Increase pressure to bead tank, or |
|
| adjust bead pressure regulator |
|
|
|
Spray gun will not stop spraying | Gun needle binding | Clean, repair |
|
|
|
| Obstructed or worn needle seat | Clean or replace |
|
|
|
Spray gun will not spray | Bead line clogged | Clear |
|
|
|
| Bead valve closed | Open |
|
|
|
| Clogged orifice or needle seat | Clean |
|
|
|
| No trigger or actuator air pressure | Check, clean air lines |
|
|
|
| Wet beads | Drain beads from tank and replace |
|
| with dry beads. |
|
|
|
8308612
