![](/images/new-backgrounds/1150115/15011521x1.webp)
4. | Remove the fluid tube and fittings. |
5. | Remove the fluid inlet bracket. |
6. | Install the new bracket (3) from the kit loosely. See |
| FIG. 3. |
7. | Place the spacer (5) in the barrel inlet. Apply Graco |
| dielectric grease (4) to the |
| both threads of the fluid fitting (2). Thread the fitting |
| into the barrel inlet. |
8. | Thread the nut (1d) onto the fitting (2). Make sure |
Installation
12. Reconnect the fluid and air lines to the gun.
5 | 2 | |
1b | ||
2a | ||
1c | ||
2b | 1d |
| the ferrules (1c and 1b) are on the tube (1a) and are |
| seated on the fitting (2) before tightening the nut |
| (1d). |
9. | Slide the tube case (1e) onto the barrel inlet, over |
| the |
| slightly. |
10. | Insert the end of the coiled tube (1a) into the bracket |
| (3). Make sure the ferrules (1c, 1b) seat on the |
| bracket. |
11. | Secure the bracket by tightening the swivel (A). |
| Tighten the nut (1d). Reinstall the exhaust tube (B) |
| and clamp (C). |
1e
1a
1e
1e 1e
FIG. 3: 244919 Conversion Kit
3
A
B
C
1e
ti10674a
309292S | 11 |