Tip and Guard on Gun
AA30 Gun with RAC Tip (257096)
1.Relieve pressure, page 2.
2. | Insert seat housing (27) | 29 | 27 |
| into guard (29). |
|
|
3. | Insert SwitchTip (28). |
| 27a 27b |
4. | Insert seal (27b) over | ti8249a | 28 |
| seat (27a) and insert in |
|
|
| seat housing (27). Use black seal for | ||
| materials and orange for solvent and | ||
| materials. |
|
|
NOTICE
If air cap is not fully installed on gun, fluid pressure can force paint into air line and damage sprayer.
5.Install guard (6) over end of gun. Hand tighten firmly to ensure a good seal.
6.Replace seat (33a) and/or retighten guard nut if you notice fluid leaking from front of gun.
AA30 Gun with Flat Tip (257380)
1. Relieve pressure, page 2.
2. | Insert spray tip into flat tip air |
|
| cap assembly. Insert spray tip | A |
| locating tab (A) into air cap | |
|
| |
| locating slot (B). |
|
3. | Install guard over end of gun. | B |
| ||
| Hand tighten firmly to ensure a | ti13263a |
| good seal. |
|
Operation
Note: The following instructions are for guns used with Graco FinishPro Sprayers. See the sprayer instruction manual 313316. If you are using a different sprayer, see your equipment instruction manual.
Operation
Setup
1.Prime sprayer. See manual 313316.
2.Slide air on/off valve on (up).
ti12855a
3. Turn air adjustment valve off at gun.
ti13321a
4.Increase fluid pressure to eliminate tails.
ti13279a
5.Decrease fluid pressure until just before tails start to appear.
ti13280a
6. Increase air pressure with air adjustment valve to eliminate tails.
7. Slide air on/off valve off (down) |
| |
when finished spraying to save | ti13281a | |
proper air pressure setting. | ||
|
Spray
1.Unlock trigger lock.
2.Be sure the arrow shaped tip (B) faces forward (spray) (257096).
3.Hold gun perpendicular and approximately 12 in. (304 mm) from surface. Move gun first, then pull gun trigger (D) to spray a test pattern.
4.Do not spray in an arc. This causes an uneven fluid coat. Spray in a path parallel to the surface, with a 50% overlap, to obtain an even fluid coat.
|
|
|
|
|
|
| WRONG | ||
|
| RIGHT |
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
313347C | 3 |
