Graham Field 707AC, 707AX user manual beverages, before a measurement

Troubleshooting

Error indicators

Indication	Cuff pressure reaches 330mmHg
Cause	Twisted bladder inside cuff
Correction	Ensure that bladder lies flat within cuff
Indication	"Err" displays, cuff pressure releases, then "0 pressure" displays
Cause	Excessive arm movement or talking during measurement
Correction	Turn monitor OFF then ON and measure again while remaining still
Indication	Could not obtain pulse rate
Cause	Cuff was too loosely applied, extremely weak pulse, or arrhythmia
Correction	Reapply cuff and measure again; if problem persists after cuff is

beverages, before a measurement.

4.Remove any clothing on the upper arm to place the cuff directly on the skin. Constriction of the upper arm by clothing or a rolled-up sleeve, as shown at right, may cause an inaccurate reading; remove any constricting garments.

5.Sit down in a chair with back support and place both feet on the floor.

6.Extend the arm from which the blood

pressure will be taken to the front or side. Rest your hand, palm-up, on a table as shown at right.

excessive

constriction

correctly positioned, seek medical attention immediately

Batteries are exhausted. Replace with four new AAA alkaline batteries

Labtron Digital Blood Pressure Monitor 14

707A-INS-LAB-RevC08-book.indd 7

Note: Place the cuff at the same level as your heart to obtain accurate measurements. Your heart is located slightly to the right of your left armpit.

Labtron Digital Blood Pressure Monitor 7

1/3/08 11:36:35 AM