Graham Field 707AX, 707AC user manual Recommended care and maintenance

7.Attach the cuff: Hold the area of the cuff where the hose exits the cuff firmly against the inside of the bare upper arm directly over the brachial artery, and the bottom of the cuff approximately one inch (2-3cm) above the elbow, as shown in the third pic- ture at right. Never place the cuff over clothing. Pull the opposite end of the cuff snugly around the arm and secure with the Velcro® fastener. The cuff should be snug, but not too tight. If one or two fin- gers can fit between the cuff and the arm, the cuff is properly secured. If you are unable to fit the cuff as described above, a smaller or larger cuff should be used.

Labtron Digital Blood Pressure Monitor

707A-INS-LAB-RevC08-book.indd 8

1 inch

8

MAINTENANCE

Recommended care and maintenance:

Do not drop or pull excessively on monitor components or subject them to strong impact.

Do not use monitor close to any device with a strong electrical field such as television, microwave oven, X-Ray equipment, etc.

Never inflate cuff above 300mmHg. Never inflate cuff unless it is positioned on an arm.

Do not expose the monitor components to direct sunlight, high temperature, or high humidity.

Do not put any part of monitor in contact with sharp objects which could pierce the material and cause damage.

Do not dismantle or disassemble monitor components.

Cleaning	Wipe off all components with a clean, dry cloth. Do not use solvents or other
	petroleum-based cleaners. Do not press cuff with a hot iron.
Storage	Always deflate the cuff completely before storage.
	Remove the batteries when the device is to be stored for extended periods of
	time. Note: Removing the batteries will erase all readings in memory.
Labtron Digital Blood Pressure Monitor		13
	1/3/08	11:36:36 AM