Beforeassemblingthe patioheater,use the parts
list to check that all necessaryparts have been included.Inspectpatio heaterfor damageas you
proceedDonotassembleoroperatethepatioheater. if it appearsdamagedIf. you havequestionsduring the assembly process, call
8am- 8pmCST,MondaythroughFriday.
CAUTION:
Removeall partsand hardwarefrom shippingbox. Referto thepartslistandhardwarepackillustrations andassemblethepatioheateron a protectivework surfaceto avoidscratchingheatersurfaces.
•Protective gloves
•Eye protection
•One #2 Phillips Head Screwdriver
•One Adjustable Wrench
Attach the Reflector (Parts List Item #1) onto Emitter Grid (Parts List Item #2) by using 3 of the 1/4" Spring Washers and 1/4" Cap Nuts provided. See Fig. 1. Use adjustable wrench
to tighten the Nuts.
2.Position the assembled Emitter Grid and Reflector onto the Burner Assembly. See Fig. 2. Rotate the Emitter Grid so the vertical welding line is in the back and the screw holes line up with the holes on Burner Assembly. Insert 4 of the M4xl0 mm round head screws and tighten securely.
3.Position the top assembly (created in figures 1 and 2) on the Base. Be sure to line up the 4 Tabs on Burner Assembly with the 4 openings
on Base. Make sure the Cylinder Access Door is located in the back and the Control Knob is
located in front. Push the Burner Assembly downward onto Base until the Tabs snap into place. See Fig. 3.
Figure 1
REFLECTOR
EMITTER
GRiD
Figure 2
REFLECTOR
EMITTER
GRID
ASSEMBLY
Figure | 3 |
|
HOLE | ON | BASE |
FORTAB | EMITTER | |
|
| GRID |
BURNER
ASSEMBLY
TAB ON BURNER
ASSEMBLY