TABLE 10: CHANNELS PAGE DEFINITIONS
SIP User ID User account information, provided by VoIP service provider (ITSP).
Usually in the form of digit similar to phone number or actually a phone
number.
Authentication ID SIP service subscriber’s Authenticate ID used for authentication. Can be
identical to or different from SIP User ID.
Authentication Password SIP service subscriber’s account password for GXW-410xv to register to
(SIP) servers of ITSP.
Profile ID Select the corresponding Profile ID (1/2/3)
Call Progress Tones Using these settings, user can configure tone frequencies according to user
preference. By default, the tones are set to North American frequencies.
Frequencies should be configured with known values to avoid
uncomfortable high pitch sounds. ON is the period of ringing (ON time in
ms) while OFF is the period of silence. In order to set a continuous ring,
OFF should be zero. Otherwise it will ring ON ms and a pause of OFF ms
and then repeat the pattern.
• “Dial tone”
• “Ringback tone”
• “Busy/Re order tone”
• “Confirmation tone”
Channel Voice Settings Channel voice settings mentioned below.
Tx to PSTN Audio Gain
(dB)
Allows user to set a value in dB for transmission to PSTN Audio Gain.
Rx from PSTN Audio
Gain (dB)
Allows user to set a value in dB for receive from PSTN Audio Gain.
Silence Suppression This controls the silence suppression/VAD feature of G723 and G729. If set
to “Yes”, when a silence is detected, small quantity of VAD packets (instead
of audio packets) will be sent during the period of no talking. If set to “No”,
this feature is disabled.
Echo Cancellation When set to Y, Echo cancellation is enabled.
Channel specific Setting Channel specific settings mentioned below.
DTMF Method This parameter specifies the mechanism to transmit DTMF digits. There
are7 modes supported: in audio which means DTMF is combined in audio
signal (not very reliable with low bit-rate codec), via RTP (RFC2833), or via
SIP INFO. Multiple DTMF transmission schemas can be selected.
1 – in-audio
2 – RFC2833
3 – in-audio and RFC2833
4 – SIP Info
5 – in-audio and RFC2833
6 – SIP Info and RFC2833
7 – in-audio, RFC2833, and SIP Info
No Key Entry Timeout Default is 4 seconds.
Grandstream Networks, Inc. GXW-410xv User’s Manual Page 17 of 30
Firmware 1.0.0.36 Updated: 11/2006