Grandstream Networks GXW410X

Grandstream Networks, Inc. GXW410x User Manual Page 25 of 35

Firmware Version 1.3.4.13 Last Updated: 3/2012

TABLE 11: DIAL PLAN PAGE DEFINITIONS

Dial Plan The Dial Plan feature implemented is applicable for VOIP to PSTN calls only. You

may configure a dial plan based on the following grammar:

1. Accept Digits: 1,2,3,4,5,6,7,8,9,0,*,#,A,a,B,b,C,c,D,d

2. Grammar:

x - any digit from 0-9;

xx+ - at least 2 digit number;

xx. - at least 2 digit number;

^ - exclude;

[3-5] - any digit of 3, 4, or 5;

[147] - any digit 1, 4, or 7;

<2=011> - replace digit 2 with 011 when dialing

WARNING - illegal input will fall back to default

Example 1: {[369]11 | 1617xxxxxxx} - Allow 311, 611, 911, and any 10 digit

numbers of leading digits 1617.

Example 2: {^1900x+ | <=1617>xxxxxxx} - Block any number of leading digits

1900 and add prefix 1617 for any dialed 7 digit numbers.

Example 3: {1xxx[2-9]xxxxxx | <2=011>x+} - Allow any length of number with

leading digit 2 and 10 digit-numbers of leading digit 1 and leading exchange

number between 2 and 9;

If leading digit is 2, replace leading digit 2 with 011 before dialing

Example 4: { [x#]+ | [x*]+ } -

llow any length of number with leading * or

# in number to dial.

Default: PSTN Outgoing - {x+}

Note: If you do not plan to use this feature set to default {x+}

Hookflash Duration

(X10ms) Default 600ms. This value can accept any value in the 100-2000ms range.

Use DTMF Parameter

from RFC2833 or SIP Info

Default Yes, No means to use DTMF parameter settings according to DTMF Digit

Length, DTMF Digit Volume and DTMF Dial Pause.

DTMF Digit Length Default value is 100ms. Please note that the value will be multiplied by 10ms

DTMF Digit Volume Default value is -11dB.

DTMF Dial Pause Default value is 100ms. Please note that the value will be multiplied by 10ms.