Grandstream Networks HT704, HT702 user manual Placing a Phone Call, Phone or Extension Numbers

PLACING A PHONE CALL

PHONE OR EXTENSION NUMBERS

1.Dial the number directly and wait for 4 seconds (Default “No Key Entry Timeout”); or

2.Dial the number directly and press # (Use # as dial key” must be configured in web configuration).

Examples:

1.Dial an extension directly on the same proxy, (e.g. 1008), and then press the # or wait for 4 seconds.

2.Dial an outside number (e.g. (626) 666-7890), first enter the prefix number (usually 1+ or international code) followed by the phone number. Press # or wait for 4 seconds. Check with your VoIP service provider for further details on prefix numbers.

DIRECT IP CALLS

Direct IP calling allows two parties, that is, a FXS Port with an analog phone and another VoIP Device, to talk to each other in an ad hoc fashion without a SIP proxy.

Elements necessary to completing a Direct IP Call:

1.Both HT70X and other VoIP Device, have public IP addresses, or

2.Both HT70X and other VoIP Device are on the same LAN using private IP addresses, or

3.Both HT70X and other VoIP Device can be connected through a router using public or private IP addresses (with necessary port forwarding or DMZ).

HT70X supports two ways to make Direct IP Calling:

Using IVR

1.Pick up the analog phone then access the voice menu prompt by dial “***”

2.Dial “47” to access the direct IP call menu

3.Enter the IP address after the dial tone and voice prompt “Direct IP Calling”

Using Star Code

1.Pick up the analog phone then dial “*47”

2.Enter the target IP address.

Note: NO dial tone will be played between step 1 and 2.

FIRMWARE VERSION 1.0.3.1 HT70X USER MANUAL Page 18 of 52