2-2 Attaching Muffler Guard
Locate the two exhaust diverters (P#J0251 w/
Figure 3. | Mower’s Exhaust |
Exhaust Diverter
2-3 Attaching Frame Mount Brackets
To mount the frame brackets which support the bagger unit, you must first remove the existing rear bumper. This can be done by removing the three bolts and nuts attaching the bumper to each side. Set the nuts and bolts aside as they will be used to mount the frame brackets. See Figure 4 for bracket orientation. Mount the left frame mount bracket (Figure 5) by using three of the existing bolts and three of the existing nuts. Tighten nuts and bolts. The right frame mount bracket will mount along with the PTO arm assembly (Figure 6). Align the hole pattern on the side of the PTO arm assembly to the hole pattern on the right frame mount bracket and mower frame. Place each of the three remaining bolts one at a time through the PTO Arm assembly, the right frame bracket and through the existing holes of the mower frame. Fasten the upper hole by using (1)
.Figure 4.
Right
Left
Rear Of
Mower
3 Existing
Bolts Here
NOTE: Right and left views are as seen from drivers perspective.
Figure 5.
Left Frame
Mount Brkt.
Figure 6. | Right Frame | Fasten Here With |
| Mount Brkt. | 3/8” x 1” HHCS |
|
| 3/8” Flange Nut |
Use 3 Existing Bolts To Mount | PTO Arm Assembly | |
PTO Assy. Along With | ||
| ||
Right Frame Mount Brkt. |
| |
To Tractor’s Frame. |
|
6