|
| |
Connection |
|
|
The safety interlock harness is located inside of the right | Figure 9. | |
| ||
PTO arm assembly (Figure 7). To install the harness to |
| |
the mower, lift the hood of the mower for engine |
| |
compartment access. Route the harness as shown |
| |
towards the parking brake switch bracket on the mower |
| |
(Figure 8). Fasten the harness to the mower’s rear frame |
| |
by using (1) zip tie P#(J0245) to prevent the harness |
| |
from rubbing the mower’s tire. Next, remove the (2) bolts |
| |
(Figure 9) from the parking brake switch bracket for |
| |
access to the brown/yellow and red/violet wires. Remove |
| |
the brown/yellow wire from the parking brake switch and |
| |
connect to the brown/yellow wire of the harness. |
| |
Connect the red/violet wire to the parking brake switch, |
| |
where the brown/yellow wire was removed (Figure 10). |
| |
Replace the bolts removed from the parking brake |
| |
switch. |
|
|
Figure 7. |
| Parking Brake |
|
| |
|
| Switch Bolts |
|
| Figure 10. |
Free End Of | Harness |
|
Harness For | Connected |
|
Routing | Here |
|
Figure 8. |
|
|
|
| 7 |
