Greenheck Fan PVF Routine Maintenance, Combustion Blower Motor, Burners and Orifices, Warranty

Models: PVF

1 8
Download 8 pages 38.41 Kb
Page 8
Image 8
Routine Maintenance

Routine Maintenance

CAUTION!!!

Turn off all gas and electrical power to the unit before performing any maintenance or service operations to this unit.

Combustion Blower Motor

Motor maintenance is generally limited to cleaning. Cleaning should be limited to exterior surfaces only. Removing dust and grease build-up on the motor housing assures proper motor cooling. Use caution and do not allow water or solvents to enter the motor or bearings. Under no circumstances should motors or bearings be sprayed with steam, water or solvents. The motor bearings are pre-lubricated and sealed, requiring no further lubrication.

Burners and Orifices

Before each heating season, examine the burners and gas orifices to make sure they are clear of any debris such as spider webs, etc. Clean burner as follows:

Turn off both electrical and gas supplies to the unit.

Disconnect union between manifold and gas valve.

Remove manifold and burner assembly.

Inspect and clean orifices and burners as necessary. Avoid using any hard or sharp instruments which could cause damage to the orifices or burners.

-Remove any soot deposits from the burner with a wire brush.

-Clean the ports with an aerosol degreaser or compressed air.

-Wipe the inside of the burner clean. Cleaning the burner with a degreaser will slow the future buildup of dirt.

Before reinstalling the burner assembly, look down the heat exchanger tubes to make sure they are clear of any debris.

Reinstall manifold and burner assembly, reconnect wire leads, and gas supply piping.

Turn on the electrical power and gas supply.

Follow the start-up procedure to light the burners and verify proper operation.

Heat Exchanger

The heat exchanger should be checked annually for cracks and discoloration of the tubes. If a crack is detected, the heat exchanger should be replaced before the unit is put back into operation. If the tubes are dark gray, airflow across the heat exchanger should be checked to make sure the blower is operating properly.

Flue Collector Box

The flue passageway and flue collector box should be inspected prior to each heating season and cleared of any debris.

Electrical Wiring

The electrical wiring should be checked annually for loose connections or wiring deterioration.

Replacement Parts

When ordering replacement parts, include the complete unit model number and serial number listed on the unit rating plate.

Warranty

Greenheck warrants this equipment to be free from defects in material and workmanship for a period of one year from the purchase date. Any units or parts which prove to be defective during the warranty period will be repaired or replaced at our option.

The motor is warranted by the motor manufacturer for a period of one year. Should the motor prove defective during this period, it should be returned to an authorized motor service station.

Greenheck will not be responsible for any installation or removal costs.

Copyright © 2001 Greenheck Fan Corp.

ERCH - PVF IOM FS

Rev1 July 2001

Page 8
Image 8
Greenheck Fan PVF Routine Maintenance, Combustion Blower Motor, Burners and Orifices, Heat Exchanger, Flue Collector Box