Part Number 452723
End Switch Kit
For use on WD series Dampers
Field Installation Instructions
These instructions apply to the field installation of end switch kits on Greenheck model WD Backdraft Dampers. These end switch kits can be used in conjunction with
End switches are typically wired to a fan and/or to a light serving as an open/not open indicator. When the damper is powered open, one of the damper blades makes contact with the spring rod of the end switch which in turn makes a connection allowing power to flow to the fan and/or light. This set up would be used when it is desirable to ensure that the damper is fully open before the fan starts.
Instructions:
1.Position end switch such that the back side of damper blade trips the spring rod.
2.Mount end switch bracket to damper frame or ductwork using #10 x 1⁄2 in.
| 3 | Damper Frame |
|
| |
Damper |
| 2 |
Tie Bar |
|
1⁄2
Part # | Qty. |
| Description |
|
|
|
|
|
|
|
|
|
|
| |
1 | 1 | End switch mounting bracket |
|
| 3 |
| |
2 | 1 | End switch |
|
|
|
|
|
|
| UL/CSA Rating L67 |
|
|
|
| |
|
| 15 Amps: | 125, 250, or 480 VAC |
|
|
|
|
|
| 0.25 Amps: | 250 VDC | 1 | Spring Rod | ||
|
| 0.50 Amps: | 125 VDC | Damper |
|
| |
|
|
|
|
|
| ||
3 | 2 | Blade | 4 |
| |||
|
| nuts (packaged in end switch housing) |
|
|
|
| |
|
|
| End Switch Installation On |
| |||
|
|
|
|
|
| ||
4 | 2 | #10 x 1/2 in. |
|
| |||
|
|
| |||||
|
| screws |
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Damper Frame
Fan or
Light
L1
L2
| N.C. | |
End | Common | N.O. |
Switch |
| M |
|
| Green |
|
| Damper |
|
| Actuator |
Damper
Blade
Damper
Tie Bar
4
3
Spring Rod
1
Note: Some actuators are
Wiring Illustration
3
2
1⁄2
End Switch Installation On
Copyright © 2008 Greenheck Fan Corporation #452723 End Switch Rev 3 Aug 2008