Grindmaster AT-AP/AT-APE, AT-TC/AT-TCE Brew Volume Adjustment, Brew Basket Rail Adjustment

COFFEE PREPARATION PROCEDURES (Pour-Over Mode)

1)Place filter into brew basket.

2)Put the proper amount of coffee into the filter.

3)Slide the brew basket into holder.

4)Place empty decanter on warmer located directly under the brew basket and turn corresponding warmer switch ON. NOTE: For airpots, open airpot lid, remove pump stem from airpot and place airpot opening directly under center hole in brew basket.

5)Pour decanter of fresh water through pour-in opening at top of brewer.

6)Hot water will be delivered through the sprayhead. This distributes the hot water evenly over the coffee bed within the brew basket. The coffee will drain from brew basket into the container below.

7)TURN OFF WARMER WHEN NOT IN USE. (Red light indicates warmer is ON.) Not for airpot brewers.

8)Before brewing next pot, remove brew basket from brew rails and dump filter into waste basket.

COFFEE PREPARATION PROCEDURES (Auto Mode)

1)Place filter into brew basket.

2)Put the proper amount of coffee into the filter.

3)Slide the brew basket into holder.

4)Place empty decanter on warmer located directly under the brew basket and turn corresponding warmer switch ON. NOTE: For airpots, open airpot lid, remove pump stem from airpot and place airpot opening directly under center hole in brew basket.

5)Press Brew switch once then release.

6)Valve will turn on approximately 1 minute and fill pour-in basin.

7)Hot water will be delivered through the sprayhead. This distributes the hot water evenly over the coffee bed within the brew basket. The coffee will drain from brew basket into the container below.

8)TURN OFF WARMER WHEN NOT IN USE. (Red light indicates warmer is ON.) Not for airpot brewers.

9)Before brewing next pot, remove brew basket from brew rails and dump filter into waste basket.

10)Do not press Brew switch more than once during brew cycle.

BREW VOLUME ADJUSTMENT

1)Disconnect power to brewer.

2)Remove plug on upper left side of chassis.

3)With a flat head screwdriver, turn dial clockwise slightly to increase volume and counter-clockwise to decrease volume.

4)Reconnect power and run a brew cycle to check volume.

5)Repeat steps 1-3 if necessary.

BREW BASKET RAIL ADJUSTMENT

1)Disconnect power to brewer.

2)Remove lid and pour-in basin.

3)Loosen nuts for brew rails.

4)Fit basket in place.

5)Tighten nuts and check basket fit.

Auto Series Brewer Manual Page 5