3.Align the tuners perpendicular to the edge of the headstock and parallel to each other as shown in Figure 13. Use a strip of masking tape to secure their position on the head- stock.
2.Push the thicker black audio jack wire through the hole shown in Figure 15.
Tuner
Mounting Hole
Figure 13. Tuners aligned to edge of headstock.
4.Using a 1⁄16" drill bit in a drill press, drill 3⁄8" deep holes into the back of the headstock through each tuner mounting hole.
Note: Drilling the holes deeper than 3⁄8" could result in drilling out through the front face of the headstock. Use a depth stop or tape wrapped around the drill bit at the correct depth as an indicator.
5.Secure the tuners to the guitar headstock with the 2.1 x 14mm screws.
Pick Guard
Components and Hardware Needed: | Qty |
Guitar Body | 1 |
Pick Guard | 1 |
To attach the pick guard to the guitar body:
1.Push the thin black ground wire through the hole that leads to the cavity in the back of the guitar shown in Figure 14.
Ground Wire
Hole
Figure 14. Ground wire hole.
Ground
