| Useful Information |
Error messages |
|
|
|
Error message | Cause & solution |
Failed | LPhonebook copy failed. Confirm the other handset |
| (the receiver) is in standby mode and try again. |
Incomplete | LThe receiver’s phonebook memory is full. Erase the |
| unnecessary phonebook entries from the other |
| handset (the receiver) and try again. |
Memory Full | LThe handset’s phonebook memory is full. Erase |
| unnecessary entries (page 16). |
You must first subscribe | LYou must subscribe to Caller ID service. Once you |
to Caller ID. | receive caller information after subscribing to Caller |
| ID service, this message will not be displayed. |
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Telephone
Problem | Cause & solution |
w is flashing. | LThe handset is not registered to the base unit. |
| Register it (page 27). |
| LThe handset is too far from the base unit. Move |
| closer. |
| LThe AC adaptor is not connected. Check the |
| connections. |
| LYou are using the handset or base unit in an area |
| with high electrical interference. Place the handset |
| and base unit away from interference sources, such |
| as antennas and mobile phones. |
The handset display is blank. | LThe handset is in screen saver mode (page 10). |
| Press {ih} to activate the handset display again. |
| LThe handset is not turned on. Turn the power on |
| (page 10). |
The handset will not turn on. | LMake sure that the batteries are installed correctly |
| (page 9). |
| LFully charge the batteries (page 9). |
| LClean the charge contacts and charge again (page |
| 9). |
33
