10 • Operation & Maintenance
Operation
The fan pull chain controls power to the fan.
•The pull chain has four settings in sequence: High, Medium, Low, and Off.
•Pull the chain slowly to change settings.
•Release slowly to prevent the chain from recoiling into the blades.
•The chain uses a breakaway connector that separates if the chain is jerked. If this happens, simply reinsert the chain into the connector.
The light pull chain controls the power to the light fixture.
• The chain has two settings: ON and OFF.
Problem: Noisy operation
•Tighten the blade assembly screws and blade iron armature screws until snug.
•Check to see if a blade is cracked. If so, replace all the blades.
Problem: Excessive wobbling
If your fan wobbles when operating, use the enclosed balancing kit and instructions to balance the fan.
Tighten all blade iron screws.
Turn power off , support fan very carefully, and check that the hanger ball is properly seated.
If you have tried these troubleshooting solutions and still have trouble, visit our Web site at: http://www.hunterfan.com.
Hunter Fan Company
7130 Goodlett Farms Parkway #400
Memphis, Tennessee 38016
Troubleshooting
Problem: Nothing happens; fan does not move.
•Turn power on, replace fuse, or reset breaker.
•Loosen canopy, check all connections according to the wiring the fan section.
•Check the plug connection in the switch housing.
•Push motor reversing switch fi rmly left or right to ensure that the switch is engaged.
•Pull the pull chain to ensure it is on.
•Remove the shipping bumpers.
Other Hunter Products
Oscillating Fans |
| Humidifiers |
|
| |
|
|
|
Air Purifiers | Bath Fans |
Thermostats | Ceiling Fans |
|
To learn more about Hunter Fan Company products, please see our Web page at:www. hunterfan.com
22