Hunter Fan 42798-01 manual Tabs Toward Ceiling Peak, Note The

	2 • Installing the Ceiling Mounting Plate (continued)
	Note: The
	isolators must be
	flush against the
	ceiling. A loose
	ceiling mounting
	plate will result
	in improper
	operation
2.5	of the Auto	2.6	2
	Balance™system.
	2
			68
		65
Align the slotted holes in the ceiling mounting plate (2) with the pilot		Place a flat washer (68) on each of the two 3” wood screws (65). Insert
holes you drilled in the wood support structure. For proper alignment, use		the screws into the slotted holes in the ceiling mounting plate (2) into the
slotted holes directly across from each other.		pilot holes you drilled. Tighten the screws (65) into the 9/64” pilot holes;
		do not use lubricants on the screws. Do not over tighten.

Tabs

Toward

Ceiling Peak

2.7

2

For Angled Ceilings: Be sure to orient the ceiling mounting plate (2) so that the two tabs are pointing toward the ceiling peak.

2.8

Unbundle the wires from the fan.

Note: Your Hunter fan comes with an optional pipe/ball assembly extension pipe. If you are hanging the fan on a ceiling higher than 10 feet tall and you would like to use the enclosed optional pipe/ball assembly, follow Steps 3.5 – 3.9.

6

42798-01 • 09/16/09 • Hunter Fan Company