3“Register H.set” i #
4Select a base unit number. i# LThis number is used by the handset
as a reference only.
5Press and hold {x} on the base unit for about 3 seconds, until the registration tone sounds.
LIf all registered handsets start ringing, press {x} to stop, then repeat this step.
LAfter pressing {x}, the rest of this procedure must be completed within 1 minute.
6Wait until “Enter Base PIN” is displayed, then enter the base unit PIN (default: “0000”), then press #.
LWhen the handset has been registered successfully, w will stop flashing. If keytones are turned on (page 19), a confirmation tone will be heard.
Selecting a base unit
When “Auto” is selected, the handset will automatically use any available base unit it is registered to. When a specific base unit is selected, the handset will make and receive calls using that base unit only. If the handset is out of range of that base unit, no calls can be made.
1"(middle soft key) i Ni #
2“Select Base” i #
3Select the desired base unit number, or “Auto”. i#
LThe handset starts searching for the base unit.
Cancelling a handset
A maximum of 6 handsets can be registered to a base unit. A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This
will allow the base unit to “forget” the handset.
1"(middle soft key) i Li #
2Enter “335”.
3“Cancel Handset” i # LThe numbers of all handsets
registered to the base unit are displayed.
4Select the handset(s) you want to cancel, by pressing the desired handset number. i #
LThe selected handset number(s) will flash.
LTo cancel a selected handset number, press the number again. The number will stop flashing.
5“Yes” i#i {ih}
Cancelling a base unit
A handset can be registered to a maximum of 4 base units. A handset can cancel a base unit that it is registered to. This allows the handset to “forget” the base unit.
1"(middle soft key) i Ni#
2“Registration” i #
3Enter “335”.
4“Cancel Base” i #
5Select the base unit(s) you want to cancel, by pressing the desired base unit number. i #
LThe selected base unit number(s) will flash.
LTo cancel a selected base unit number, press the number again. The number will stop flashing.
6“Yes” i#i {ih}
Note:
LTo register the handset to another base unit or to the same base unit again, see manual registration (page 27).
28
