Tip: To quickly gauge this setting, fold a crisp dollar bill in half twice (when folded tightly, four thicknesses of a dollar bill is approxi- mately 0.016"). Place the folded dollar bill between the support bearing and the blade, as shown in Figure 32.
Figure 32.9daaVgW^aa[daYZYil^XZidbV`ZV
fj^X`%#%&+\Vj\Z#
8. I^\]iZc i]Z XVe hXgZl id adX` i]Z hjeedgi WZVg^c\^ceaVXZ#
Adjusting Blade
Guide Bearings
EgdeZganVY_jhi^c\i]ZWaVYZ\j^YZhegdk^YZhh^YZ" id"h^YZ hjeedgi id ]Zae `ZZe i]Z WaVYZ higV^\]i l]^aZXjii^c\#
I]ZgZVgZWaVYZ\j^YZWZVg^c\hdci]ZjeeZgVcY adlZgWaVYZ\j^YZVhhZbWa^Zh#7di]VY_jhi^ci]Z hVbZbVccZg#
Important: The blade is tracking and tensioned correctly before performing this procedure hZZ Tensioning Blade dcPage 23 .
Tool NeededQty
=ZmLgZcX])bb############################################## '
To adjust the upper and lower blade guides:
1. 9>H8DCC:8I76C9H6L;GDBEDL:G
"'+"
2. ;Vb^a^Vg^oZndjghZa[l^i]i]ZWaVYZ\j^YZXdc" | ||
igdahh]dlc^cFigure 33# |
| |
<j^YZ7ZVg^c\ |
| |
6Y_jhibZci | @cjgaZY | |
8VeHXgZlh | ||
@cdW | ||
| ||
| 8VeHXgZl | |
| AdX`^c\ | |
| 8VeHXgZl | |
| &d[' | |
Figure 33.7aVYZ\j^YZWZVg^c\Xdcigdah# | ||
3. AddhZc i]Z XVe hXgZl h]dlc ^c i]Z [^\jgZ VWdkZ! i]Zc jhZ i]Z `cjgaZY `cdW id VY_jhi i]Z \j^YZ WZVg^c\h aViZgVaan hd i]Z WZVg^c\ [VXZh VgZ _jhi WZ]^cY i]Z WaVYZ \jaaZi! Vh ^aajhigViZY ^c Figure 34! VcY gZ"i^\]iZc i]Z i]jbWhXgZlidhZXjgZi]ZhZii^c\#
7aVYZ
<j^YZ
7ZVg^c\
7aVYZ
<jaaZih
Figure 34.7aVYZ\j^YZWZVg^c\edh^i^dcZY_jhi
WZ]^cYi]ZWaVYZ\jaaZih#
Note: With wider blades, it may not be possi- ble to bring the guide bearings just behind the blade gullets. Position them as far forward as possible without allowing the guide bearing housing to touch the back of the blade.
The set of the teeth increase the chance of the bearings contacting the teeth during a cutting operation as the set of the teeth is wider than the blade. The support bearing must be set to prevent this.
