SECTION 5: ADJUSTMENTS

Belt Replacement

 

Belt Tracking

 

 

 

 

 

 

With the exception of Belt Tracking, adjustments to your Combination Sander should be made with the power off and the machine unplugged.

Unlock the Quick-Release Lever by pulling the lever straight out. Figure 12. Slide the belt off the rollers straight toward you. Reverse this process to install a new belt.

Figure 12.

The goal of this procedure is to achieve proper belt tracking that prevents the belt from wander- ing off to either side.

1.To adjust the tracking, quickly turn the sander on and off. Observe the belt’s behav- ior. If the belt moves to one side or the other, you will need to adjust the tracking knob.

Figure 13.

Figure 13.

2.Turn the knob approximately 14 turn clock- wise to move the belt towards the tracking knob, counter-clockwise to move the belt away.

3.Turn the machine on and off again quickly to see if the tracking has improved. If not, repeat step 1. If tracking is improved move to step 4.

4.Now with the sander running, adjust the knob to fine tune the belt tracking.

 

 

 

 

 

 

 

 

 

 

 

 

-12-

G1014Z Combination Sander

Page 14
Image 14
Grizzly G1014Z instruction manual Adjustments, Belt Replacement Belt Tracking