-18- G1028Z/G1029 Dust Collector
The best way to plan your new system is to draw
a bird’s eye view (as shown in Figure 14)of your
shop and sketch the following:
1. Your desired location of the dust collector,
usually in a corner or along a wall.
2. The location of each machine in the system.
3. The location of the main line duct and each
branch line.
4. The location of any obtrusion such as a joist
or heating duct, that will require special duct
routing.
Figure 14. Bird’s eye planning view.
6''
5''
4''
4''
4''
4'' 4'' 4''
4''
Main Line
Branch Line
When designing a successful dust collection sys-
tem, planning is the most important step. Before
you set out to run the first section of duct, consid-
er these general guidelines for an efficient sys-
tem:
1. Machines that produce the most saw dust
should be placed nearest to the dust collec-
tor. These machines include thickness plan-
ers, shapers, sanders and bandsaws.
2. Ideally, you should design the duct system to
have the shortest possible mainline run and
to have short secondary branch ducts.
3. Directional changes should be kept to a min-
imum. The more directional change fittings
you use, the greater the loss of overall pres-
sure.
4. Gradual directional changes are more effi-
cient than sudden directional changes (i.e.
use the largest corner radius possible when
changing hose or pipe direction).
5. Each individual machine should have a blast
gate to control suction from one machine to
another.
6. The simpler the system, the more efficient
and less costly it will be.
Design SuggestionsDust
Collector